Dr. Fixit does not offer any gifts/vouchers/discount coupons etc. in exchange of personal details or particulars. Please note that we have/will not authorise(d) any communication in this regard and any such information should be disregarded. Any communication of this nature is not endorsed by Dr. Fixit or Pidilite Industries.
Dr. Fixit does not offer any gifts/vouchers/discount coupons etc. in exchange of personal details or particulars. Please note that we have/will not authorise(d) any communication in this regard and any such information should be disregarded. Any communication of this nature is not endorsed by Dr. Fixit or Pidilite Industries.
Home > Professional New > HARD SCAPE - 10 Years

HARD SCAPE - 10 Years

DR. FIXIT FLEXI PU 270(I)

 

One component polyurethane membrane for long lasting waterproofing

  • BRUSH APPLIED,TOUGH SEAMLESS MEMBRANE
  • System Life Expectancy – 10 years.

Method Statement

SURFACE PREPARATION

1. Clean the surface thoroughly to get rid of all contaminants. Remove all surface imperfections and loose surface pieces.

2. Prime locally with the Dr. Fixit Primer PU or Dr. Fixit Pidipoxy MIEP and allow 2-3 hours to dry. Fill all prepared cracks with Dr. Fixit PU sealant.

3. Use PU Primer if the moisture content is less than 4% and use MIEP Primer if the moisture content is 5-8% and allow the primer to cure according to the technical instruction.

4. Maximum moisture content should not exceed 5%. Do not wash the surface with water.

APPLICATION

1. Pour the Dr. Fixit Flexi PU 270(I) onto the primed surface and lay it out by roller or brush, until the whole surface is covered, maintaining the spreading rate to achieve the desired dry film thickness of 1.4 mm. You can use airless spray allowing a considerable saving of manpower.

2. After 12-18 hours (not later than 48 hours) apply another layer of the Dr. Fixit Flexi PU 270(I). For demanding applications, apply a third layer of the Dr. Fixit Flexi PU 270(I).

3. Reinforce always with the Geotextile Fabric at problem areas, like wall-floor connections, 90º angles, chimneys, pipes, waterspouts (siphon), etc.

4. Spread minimum 100 gsm geotextile over cured Dr. Fixit Flexi PU 270(I) as separation layer, before a concrete screed is laid.

5. Protect the coating with a concrete screed of M20 grade with a thickness of 40-50 mm (minimum) maintaining an average slope of 1:100 towards the drain outlets for effective and efficient draining of water.

6. For best results, the temperature during application and cure should be between 5ºC and 35ºC. Low temperatures retard cure while high temperature speed up curing. High humidity may affect the final finish.

CAD Diagram

Technical data Sheet

Dr. Fixit Flexi PU 270(I)

3D Diagram

Pidilite